All articles

How to apply protector sprayUpdated 2 months ago

To apply Dasco Protector Spray to boots, first ensure the boots are clean and dry. Shake the can well, then spray evenly from a distance of about 20cm, holding the can at arm's length. Allow the spray to dry for the recommended time (usually 10-30 minutes) before wearing the boots. 

Here's a more detailed breakdown:

  • 1. Prepare the boots:
    Brush off any loose dirt or debris from the boots. If the boots are new, you may not need to clean them, but if they are pre-worn, cleaning can improve the spray's effectiveness. 

  • 2. Shake the can:
    Ensure the Dasco Protector Spray is well-mixed by shaking the can thoroughly. 

  • 3. Spray evenly:
    Hold the can about 20cm (approximately arm's length) away from the boots and spray in a sweeping, even motion, ensuring the entire surface is covered. 

  • 4. Allow drying:
    Let the treated boots dry completely before wearing them. This usually takes around 10-30 minutes, but refer to the product instructions for the specific drying time. 

  • 5. Reapply as needed:
    For optimal protection, reapply the Dasco Protector Spray regularly, especially after cleaning the boots or when you notice a decrease in water repellency. 

Important Notes:

  • Test in a small area:
    Before applying the spray to the entire boot, test it on a small, inconspicuous area to ensure it doesn't darken the boot's color, especially with lighter shades. 

  • Ventilation:
    Apply the spray in a well-ventilated area, or even better, outdoors, as the spray can have a strong odor. 

Follow instructions:
Always refer to the specific instructions on the Dasco Protector Spray packaging for the most accurate and up-to-date information. 

Was this article helpful?
Yes
No